Brew this month
Chugger X-Dry Tri-Clamp Stainless Pump, 115VChugger X-Dry Tri-Clamp Stainless Pump, 115V, view 2Chugger X-Dry Tri-Clamp Stainless Pump, 115V, view 3Chugger X-Dry Tri-Clamp Stainless Pump, 115V, view 4Chugger X-Dry Tri-Clamp Stainless Pump, 115V, view 5Chugger X-Dry Tri-Clamp Stainless Pump, 115V, view 6
Chugger Pumps

Chugger X-Dry Tri-Clamp Stainless Pump, 115V

A 115V brewing pump with molded 1 1/2-inch tri-clamp fittings, run-dry carbon bearings and ETL certification; handles liquids to 250°F.

Brewing systems & chillersGoing all-grain
  • 1 1/2 in. tri-clamp
  • ETL certified
  • Up to 250°F

Best for Tri-clamp brew rigs

View on Amazon

Opens the product page with today’s price, variants and delivery. We may earn a commission at no extra cost to you. For adults 21+.

Specifications

TypeBrewing pump
Power115V
MaterialStainless pump end, 1 1/2 in. tri-clamp

As stated by the maker or seller. Specs can change between versions and sellers; confirm on the listing. We did not test this product.

From the maker

  • 1 1/2″ Molded Tri-Clamp Fittings (Not Welded)
  • Approved Run Dry Carbon Bearing Material
  • ETL Certified
  • Stainless Steel Pump End
  • Can Handle Liquids of 250° F
Electric brewing: GFCI and a licensed electricianPlug 120V and 240V systems only into a GFCI-protected circuit of the type the manual calls for, with no extension cords. A 1600 W system on 120V draws about 13.3 A (W ÷ V), close to a 15 A circuit’s limit. Have a licensed electrician install any new circuit, 120V or 240V.Source: Anvil Foundry manual (GFCI protection for 240V hookups); W ÷ V arithmetic
Strike water calculatorStrike and infusion water temperatures (Palmer).Dilution and boil-off calculatorPre-boil volume from your boil-off rate.

Full listing title: CHUGGER PUMP TRI-XCPSS-CI-1 Tri Clover X-DRY Run Dry Protection, Molded 1 1/2" Tri-Clamp Fittings, SS, 115 Volt Home Brewing System Beer Pump, ETL-Certified, Approved Carbon Bearing Material.

Compare with

All brewing systems & chillers